Wet Pour gives a high quality, hard wearing, slip-resistant surface requiring little or no maintenance. Wet Pour is a continuous rubber surface that Mixed on site, the rubber EPDM granule and polyurethane resin mixture is wet laid to various thicknesses onto a prepared area. The thickness and area of Wet Pour is determined by the free height of fall of the equipment installed. The correct thickness and area of Wet Pour is laid around each piece of equipment to provide a sufficient level of impact absorbency. Wet Pour is available in a range of colours. Although the standard colour is black, a coloured fleck can be added to enhance appearance of the finished area. Coloured shapes, logos and floor games can be laid into the surface to give an individual theme and provide additional play value. Wet Pour complies with BS EN 1177 and BS 7188. Test certificates are supplied for all thicknesses offered. All Wet Pour surfaces offered by Playdale use hard wearing EPDM rubber granules. Standard Wet Pour installation Wet Pour wearing layer (EPDM) Existing ground level Pressure treated timber edging Pressure treated timber stake Wet Pour base layer Subbase: 100 - 150mm Compacted MOT. Type 1 stone. Note: concrete should be used as subbase material for Wet Pour thickness of less than 40mm. Concrete kerb edging Wet Pour wearing layer (EPDM) Existing ground level Pre-cast concrete pin kerb edging Concrete haunching Wet Pour base layer Subbase: 100 - 150mm Compacted MOT. Type 1 stone. Note: concrete should be used as subbase material for Wet Pour thickness of less than 40mm. Wet Pour installed onto existing base Wet Pour wearing layer (EPDM) Wet Pour base layer Existing concrete / tarmac Channel cut in existing surface to prevent Wet Pour lifting at edge 266 Tel: 015395 39770 enquiries@playdale.co.uk www.playdale.co.uk Surfacing Pagina 265
Pagina 267Scoor meer met een webshop in uw archief. Velen gingen u voor en publiceerden onderwijsmagazines online.
Catalogus Playdale 2015 Lees publicatie 1Home